Hello everyone
I will introduce the Miku disposable vape
Open the outer box
tear off candy wrappers
Remove the upper silicone plug
Tear off the bottom charging port dust-proof sticker
Immediately suck
Bluelight on the bottom when puffing
Miku's disposable vape are pre-filled with 8ml e-liquid
Equivalent to the capacity of four 2ml pods
An average of 300 puffs per pods
So the 8ml is about 1200 puffs
But here is a note of 3000 mouths
All are the names of the foreign trade market
Such as other disposable pods on the market
Note 3000, 5000
Actually none of that.
In addition, the battery capacity is 400mAh
output power 10 watts
The new kit has a certain amount of power
When you feel less smoke during smoking
Indicates low battery
Can be charged using type-c interface
The bottom indicator light is always blue when charging
It can be fully charged in about 45 minutes in a low power state
When fully charged, the bottom light will turn off
Charge 3 to 4 times
You can basically use up 8 ml of e-liquid in it
How to judge whether the disposable vape is out of e-juice?
When we feel the smoke is dry
the humidity of the smoke is reduced
Not so full of smoke
You can try to open the cigarette holder and inject e-juice
Taboo pumping until it smells sticky
Otherwise, there will be a sticky smell after refill
Next, the e-juice injection method will be shown
Press the top edge of the cigarette rod with your left thumb
With the right hand, move the cigarette holder upwards
Back and forth
until it open
Above is condensed cotton
After taking out the condensed cotton
It is recommended to use a paper towel to dry the condensate in it
Below is a sealed silicone sleeve
pry open
Like this bulge stained with grease
Clean up with paper towels
By looking at the color of this e-juice storage cotton
It's really dry and needs to be filled.
It is forbidden to inject e-juice into the middle intake hole
Instead, squeeze Miku e-liquid on the e-juice storage cotton around the air intake.
No specific requirements for e-juice injection
According to the speed of the oil absorption rate of the e-juice storage cotton
Judging by color depth
When the e-liquid is saturated
E-juice absorption becomes slower
The e-juice storage cotton will be darker in color.
After filling, then put back the sealing silicone sleeve
The sealing silicone ring is a little protruding
Must be aligned with the fiber hole in the middle
Press it a little to fix it
Here we can use a cotton swab
Break both ends of the cotton swab
put it in this hole
Then press the silicone ring down
with tweezers or something
Press the silicone sleeve onto the contact surface of the cotton
pressed flat
If you don't do this
Instead, press down the silicone ring directly.
Easily pressed against the edge of the fiber tube
Causes the air intake to be blocked and the smoke cannot be drawn
After the operation is done, the middle hole looks transparent.
Then put the condensate on
Close the cigarette holder and fasten it firmly
Press to the perimeter of the rod and the edge of the mouthpiece without cracks
Stand for another 10 minutes, then it can be used normally
Because it is a one-time kit
It is recommended to fill in e-juice once or twice, then replace the rod with a new one
--------------------------------------------------------------------------------------------------
miku