How to use well of your refillable vape pods?

The e-juice injection hole is located on the side of the empty pod

Seal with silicone plug

It is recommended to refuel each empty pod and replace it with a new one after 3 to 5 times of use

After filling in the e-juice, put the pod upright and let it stand for ten minutes

After ten minutes, connect to the device and use it

Fully moisten the atomizing core of the pod to avoid burning the core

Firstly, when smoking, do not blow into the mouthpiece

When exhaling, hold the mouthpiece away from your lips

To avoid oil leakage and increased condensation

Secondly, it is not recommended to puff heavily for more than 6 seconds

or puff by lying down

or uninterrupted rapid continuous suction in a short period of time

Otherwise, the pod will easily burn the core or the e-juice will be sucked into mouth

Thirdly, do not expose electronic cigarettes to sunlight

In high temperature weather, if you place the pod with e-juce in the car for a long time

Due to the influence of temperature, it may cause e-juice leakage

If you need to store electronic cigarettes for a long time, it is recommended to put them in a sealed bag

Similarly, when flying or going to some high-altitude areas

The pods and e-liquid can be packed in a sealed bag

and squeeze the air out of the sealed bag

Avoid e-juice leakage due to changes in air pressure

Fourthly, the Platypus Pro is equipped with components with high power and relatively high battery discharge.

Therefore, the explosive power of atomization is relatively sufficient

However, long-term use will produce condensation

It is recommended that you take out the pod before and after use

turn the mouthpiece down

Wrap it in a paper towel and shake it lightly

Clean out the condensate generated in the atomization chamber

Twist the paper towels into thin strips

Stuff a paper towel into the chimney and turn it around

Wipe off the condensate attached to the flue

Fifthly, pay attention to observing the condensation groove inside the battery rod and the bottom of the pod

If there is condensation, wipe it off with a cotton swab or wet paper towel in time

So as not to cause poor contact or damage the equipment

Sixthly, when the e-liquid in the pod is almost used up, fill it in time

Avoid dry burning of the atomizing core and reduce the service life of the atomizing core

Twist the paper towel into a thin shape before filling

Use a paper towel to absorb the remaining e-juice at the bottom of the pod

Suck it all up and then inject the e-liquid, the taste will be better

Seventhly, in order to ensure the taste of Platypus PRO empty pod atomization

It is recommended that a cartridge be filled with e-juice three to five times

Replace with a new Platypus PRO pod

When you receive the Platypus PRO stick, it will be turned off by default, and you need to turn it on first.

Press the button 5 times within 2 seconds, and the indicator light flashes 3 times to start the machine

When not in use, especially in pockets, bags or uneven places

Please do not place directly

It should be turned off first, and then placed (the same way for switching on and off)

To avoid touching the button by mistake, the device works by itself

Whatsapp: +86 136 5238 8013

Telegram: +1 442-234-9389

Wechat: jeeztian